| General Description |
A Low Density (LDPE) polyethylene based thermoplastic powder coating designed for use on but not limited to wire goods and/or totally encapsulated metal products. Encase® G35 is heavy metal free and meets FDA standards for direct food contact and is compliant for “within the product zone” applications.
|
| Application Data |
| Surface preparation |
Chemical Pretreatment |
Multi-stage phosphate conversion coating may be used. Please visit with your local chemical pretreatment supplier for advice on the products that fit your application.
|
Mechanical Preparation (Grit Blasting) |
(SSPC-SP6) 2-3 mil anchor profile using clean, sharp edged blast media.
|
NOTE: Properly preparing parts before powder coating is essential for a quality finish. This includes cleaning, rinsing, drying and insuring that the substrate surface is free and clear of any contaminates. |
| Fluidized Bed |
For fluidized bed dipping, preheat parts to 400° F (adjust according to part thickness). Dip parts in fluidized bed of Encase® G35 for 4 - 6 seconds. Carefully blow off the excess powder. For improved surface finish (if necessary), parts may be post-baked for a short period of time. |
| Electrostatic Deposition |
For electrostatic deposition, preheat parts to 400° F. Deposit Encase® G35 8-12 mils thick. For improved surface finish (if necessary), parts may be post-baked for a short period of time. |
| For complete application details contact Innotek® Technical Support |
| NO CURE TIME! |
Thermoplastic powder coatings need only be heated enough to flow out the coating, nothing more. Overheating may cause degradation or embrittlement of the coating. Coating may be put into service when cooled.
|
 |
